I just got off the phone with Intel’s Steve Smith (VP and Director of Intel Client PC Operations and Enabling) and got some more detail on this morning’s 6-series chipset/SATA bug.

The Problem

Cougar Point (Intel’s 6-series chipsets: H67/P67) has two sets of SATA ports: four that support 3Gbps operation, and two that support 6Gbps operation. Each set of ports requires its own PLL source.

The problem in the chipset was traced back to a transistor in the 3Gbps PLL clocking tree. The aforementioned transistor has a very thin gate oxide, which allows you to turn it on with a very low voltage. Unfortunately in this case Intel biased the transistor with too high of a voltage, resulting in higher than expected leakage current. Depending on the physical characteristics of the transistor the leakage current here can increase over time which can ultimately result in this failure on the 3Gbps ports. The fact that the 3Gbps and 6Gbps circuits have their own independent clocking trees is what ensures that this problem is limited to only ports 2 - 5 off the controller.

You can coax the problem out earlier by testing the PCH at increased voltage and temperature levels. By increasing one or both of these values you can simulate load over time and that’s how the problem was initially discovered. Intel believes that any current issues users have with SATA performance/compatibility/reliability are likely unrelated to the hardware bug.

One fix for this type of a problem would be to scale down the voltage applied across the problematic transistor. In this case there’s a much simpler option. The source of the problem is actually not even a key part of the 6-series chipset design, it’s remnant of an earlier design that’s no longer needed. In our Sandy Bridge review I pointed out the fair amount of design reuse that was done in creating the 6-series chipset. The solution Intel has devised is to simply remove voltage to the transistor. The chip is functionally no different, but by permanently disabling the transistor the problem will never arise.

To make matters worse, the problem was inserted at the B-stepping of the 6-series chipsets. Earlier steppings (such as what we previewed last summer) didn’t have the problem. Unfortunately for Intel, only B-stepping chipsets shipped to customers. Since the fix involves cutting off voltage to a transistor it will be fixed with a new spin of metal and you’ll get a new associated stepping (presumably C-stepping?).

While Steve wouldn’t go into greater detail he kept mentioning that this bug was completely an oversight. It sounds to me like an engineer did something without thinking and this was the result. This is a bit different from my initial take on the problem. Intel originally characterized the issue as purely statistical, but the source sounds a lot more like a design problem rather than completely random chance.

It’s Notta Recall

Intel has shipped around 8 million 6-series chipsets since the launch at CES. It also committed to setting aside $700 million to deal with the repair and replacement of any affected chipsets. That works out to be $87.50 per chipset if there are 8 million affected chipsets in the market, nearly the cost of an entire motherboard. Now the funds have to cover supplying the new chipset, bringing in the affected motherboard and repairing it or sending out a new one. Intel can eat the cost of the chipset, leaving the $87.50 for shipping, labor and time, as well as any other consideration Intel provides the OEM with (here’s $5, don’t hate us too much). At the end of the day it seems like enough money to handle the problem. However Intel was very careful to point out that this is not a full blown recall. The why is simple.

If you have a desktop system with six SATA ports driven off of P67/H67 chipset, there’s a chance (at least 5%) that during normal use some of the 3Gbps ports will stop working over the course of 3 years. The longer you use the ports, the higher that percentage will be. If you fall into this category, chances are your motherboard manufacturer will set up some sort of an exchange where you get a fixed board. The motherboard manufacturer could simply desolder your 6-series chipset and replace it with a newer stepping if it wanted to be frugal.

If you have a notebook system with only two SATA ports however, the scenario is a little less clear. Notebooks don’t have tons of storage bays and thus they don’t always use all of the ports a chipset offers. If a notebook design only uses ports 0 & 1 off the chipset (the unaffected ports), then the end user would never encounter an issue and the notebook may not even be recalled. In fact, if there are notebook designs currently in the pipeline that only use ports 0 & 1 they may not be delayed by today’s announcement. This is the only source of hope if you’re looking for an unaffected release schedule for your dual-core SNB notebook.

Final Words

Intel maintains that Sandy Bridge CPUs are not affected, and current users are highly unlikely to encounter the issue even under heavy loads. So far Intel has only been able to document the issue after running extended testing at high temperatures (in a thermal chamber) and voltages. My recommendation is to try to only use ports 0 & 1 (the 6Gbps ports) on your 6-series motherboard until you get a replacement in place.

OEMs and motherboard manufacturers are going to be talking to Intel over the next week to figure out the next steps. Intel plans to deliver fixed silicon to its partners at the end of February, however it’ll still take time for the motherboard makers to turn those chips into products. I wouldn’t expect replacements until March at the earliest.

I maintain that the best gesture of goodwill on Intel’s part would be to enable motherboard manufacturers to replace P67/H67 motherboards with Z68 boards for those users who want them.

POST A COMMENT

127 Comments

View All Comments

  • mike2100 - Tuesday, February 1, 2011 - link

    I hope you don't plan on sending it in right away (unless this is not a primary system for you).
    I just upgraded to SNB and already donated my old system to my parents. Intel should pay Newegg to send me a new board before I send mine to them... IMO
    Reply
  • ghitz - Tuesday, February 1, 2011 - link

    Agreed. I'm not going to be without a system even for a 1 day because of this. My new machine is my daily production machine. Reply
  • glad2meetu - Tuesday, February 1, 2011 - link

    I'll be submitting my request for a new motherboard. This is quite bad. The transistor will short circuit and probably can cause damage to other components. I won't be surprised if they do a recall within the next month or two. Intel should have just announced a recall rather than lie to their customers. Reply
  • marraco - Tuesday, February 1, 2011 - link

    If the mother is fixed by running on a lower voltage: ¿Why they used a higher voltage? ¿To waste energy?

    This looks like a lame excuse. I don't trust.

    I will no buy P67/H67.
    Reply
  • Gothmoth - Tuesday, February 1, 2011 - link

    learn to read.... it was an oversight by the engineers.

    you people can not even read a simple article but complain about engineers who have to oversee a billion transistor CPU..
    Reply
  • marraco - Tuesday, February 1, 2011 - link

    learn to read...Why they use larger voltage than necessary? Energy efficiency is important.

    They will not use a voltage level if not necessary, so it is not a fix without consequences. They are hiding something to save face, and don't should to be trusted.
    Reply
  • bruce24 - Tuesday, February 1, 2011 - link

    I'm not sure what you think they are hiding, they said the only way to fix the problem, is to replace the chipset. They have stopped shipping the bad chips and for now have put aside $700M to deal with people who have the bad chips. While there are alot of guesses posted here as to how it will be handled, people are going to have to wait to see how each OEM and MB maker decided to deal with this. Samsung has already said they will offer refunds for PC's sold with the bad chipset. Reply
  • strikeback03 - Tuesday, February 1, 2011 - link

    I highly doubt they analyze and control the voltage applied to each transistor individually. If this explanation is true I would guess it is part of a bank of transistors that all receive the same voltage. That said it does sound weird that they would insert something into the design that was at least partly irrelevant. Reply
  • JasperJanssen - Tuesday, February 1, 2011 - link

    Chips aren;t designed by humans, especially not at the transistor level. Humans assemble libraries of existing components.

    Much like software, it's entirely possible for there to be pieces of code or transistor that have been unchanged since 1995 and sometimes aren;t even used any more.
    Reply
  • catommy - Tuesday, February 1, 2011 - link

    regularly having to switch around sata ports when ssd drive not found in bios could these be related also my optical drive also not working for some time now mb msi P55 gd80' processor i5 655k' ssd kingston snvp 325s264gb, dvdcd gh22ls40 ata.My so called remedy is flash cmos when necessary including switching out sata cables from devices and ports anyway my dvd drive has not worked again ssd still ticking are these one in the same because of type of chip just wondering Reply

Log in

Don't have an account? Sign up now